APPLICATION: INSTRUCTIONS AND RECOMMENDATIONS/ STOCKING
DRIVER P APPLICATION
DRIVER P can be provided with its upper-side covered a talc, sand,or non
woven polypropylene fabric. Its underside is protected and faced with POLYFLAM EASY TORCH (reduced printed area increases product adhesion), the special non- stick polyethylene film to be flamed during laying. Support surfaces must be dry, clean and sufficiently smooth and level. Application is made by light flaming with propane gas. Laying is quick and easy. We recommend slightly heating the roll of the membrane prior.
STOCKING
Keep the products packed in the carton box in a dry place.
Keep out of direct sunlight.
Avoid stocking pallets without evenly distributing the load.
Keep the rolls standing.
Absolutely avoid puncturing the product.
Avoid application if the temperature is excessively low or high.
Avoid stamping (shoes with crampons, small objects or sharp edges)
The contat with solvents and organic liquids may damage the product.
Do not place the pallets one on top of another and the olls must always be stocked in a vertical position.
0 Comment "APPLICATION: INSTRUCTIONS AND RECOMMENDATIONS/ STOCKING"
Post a Comment